2008-10 Polaris RZR 800, RZR S 800 & RZR 4 800 PyroPak Fuel Controller
Looking to fine tune the fuel injection system of your older generation Polaris RZR 800 without all the trial and error testing required for manual adjustments. Well you’re in luck. Electronically control and tune your fuel system with DragonFire’s aftermarket PyroPak Fuel Controller. This computerized module gives you an incredible amount of control over your ride’s fuel settings. You can also adjust the engine’s ignition timing and play around with its rev-limiting functions. Your machine already has brawn, now give it some brains with the PyroPak Fuel Controller by DragonFire.
The exclusive PyroPak Fuel Controller by DragonFire optimizes your older generation Polaris RZR 800’s air/fuel ratio at all RPMs for maximized throttle response and horsepower. This EFI Control unit offers more advanced settings than any other brand. It Installs in minutes and plugs directly into the OEM wiring harness between the ignition and fuel injection control of the engine’s fuel management system. Exercise complete control of the fuel injection system. Tweak your fuel settings, adjust the ignition timing, or even set a maximum rev speed. The module can interface with other aftermarket self-tuning devices, and can be easily connected to a computer with a basic USB cable. It will optimize your engine’s air/fuel mix at every RPM level, and adjust the timing of each cylinder individually.
Be sure that you’re getting as much giddyup-and-go out of your engine as humanly possible, knowing that peak performance is being achieved. And with the PyroPak installed in your rig, it will boost the engines longevity so long as you don’t go too crazy with the rev limiter. You’re ride may be an older model, but it’s never too late to unleash the beast and ride with optimal performance. Take destiny into your own hands and install the aftermarket PyroPak Fuel Controller by DragonFire.
ECU Controller Features:
- Allows for fuel settings, ignition timing and rev-limiter adjustments
- Piggy back, plug-n-play system with the ability to tune further on the provided computer software
- USB powered from computer (9 volt adapter is no longer needed for programming)
- 2 position map switching function built in (map switch not included)
- Analog input (allows user to install any 0-5 volt sensor and build an adjustment table based on its input such as boost or temperature)
- Unit has a 1100/+250% fuel change range
- 10 throttle position columns
- Enhanced "accel pump" utility (increased adjustment and sensitivity ranges)
- Retains all of the standard PyroPak control features
- Allows +/- 20 degrees of timing adjustment
- Map switch input-change maps on the fly
- Adjust timing per cylinder
- Built in 500 rpm rev limiter extension with the click of a button in the software program
- Raise your rev limiter further with a custom provided map after liability/release waiver is signed (contact DragonFire directly for more information)