- Automotive Laminated Safety Glass with DOT Stamp
- Frame is made out of .125" Aluminum
- Black Powder-coat finish
- 3D CAD Designed and CNC Cut and formed
- Tinted Polycarbonate Vents that you can see through when closed
- Billet Aluminum Mounting Clamps
- Black Stainless Steel Bolts and Washers
- Designed & Made in the USA
- Hand Wiper Included
- only fits with stock plastic visor*
Fitment:
2015-2020 RZR 900 S, Trail, XC
2016-2020 RZR 1000 S
2014-2018 RZR XP 1000 (2 and 4 seat)
2016-2018 RZR XP Turbo (2 and 4 seat)
Glass Windshields:
- Glass is very scratch resistant but not scratch proof! While very hard and durable, glass can still be scratched if contaminants such as sand, small rocks, dirt etc. being rubbed on glass.
- Towels, windshield wipers, and squeegees can scratch glass if there are contaminants on the windshield.
- Any damage that is caused by interference from other aftermarket products will not be subject to any warranty claim.
- At time of purchase, buyer agrees to all policies, procedures, and returns processes.
- Windshields may not fit with aftermarket products such as:
- Roofs
- Stereos
- Mirrors with thick clamps
- Cab enclosures
Instructions
4 – Universal Billet Clamp 1.75”
4 – Bolt 1/4-20 × 2.5”
4 – Flat Washer 1/4”
8 – Locknut 10/24
8 – Bolt 10/24 × 1/2”
4 – Lock Washer
1 – Long Handle Assembly Left
1 – Long Handle Assembly Right
STEP ONE – Install handle assembly. Bolt the flap mount to the plastic flap using two 10-24 x 1/2” bolts. The handle should point towards the outside of the vehicle. Attach the bracket with threaded insert to the bottom side of the bend on the windshield frame using two more 10-24 x 1/2” bolts and 10-24 locknuts. Tighten bolts and loosen thumb screw to test if flap mechanism moves properly. Adjust the placement of the bracket with insert if the flap doesn’t work. make sure the left and right handle assembly is in the correct orientation as shown in the picture.
STEP TWO – Slide one of the billet clamps over the roll cage in the lower corners on each side with the bolt holes on the inside of the cage and the flat face pointed forward
STEP THREE – Carefully place the main windshield onto the front of the cage. This is much easier with two people. Position the windshield centered side to side, and lower it down to where it is just contacting the trim but can still open the vents easily. Use the 2.5” bolts to attach windshield to the installed billet clamps. Use a washer on the bolt head side. Check the position of the windshield as you tighten to make sure it doesn’t move too much. Only hand tighten as over tightening could bend the bolt and clamp.
